using hyperkin gamecube controller adapter for pc

It is no longer necessary to connect a controller (gc or N64) in order for the adapter to be detected by the computer (USB). With earlier versions, this would have required a disconnect/reconnect of the USB cable to reset the firmware.

Hopefully a better solution comes about as it would really be great to easily get this controller working properly in Nintendont, considering how perfectly designed it is for that. It is now possible hot-swap between N64 and Gamecube controllers. Then after the game has started, turn off the standard pro controller and connect the Procube Controller. The only confirmed working method I've seen of getting a Procube controller to work in Ninendont is by having that dongle set up on your vWii/Wii have a standard Wii U Pro controller connected to that when you start up your gamecube game. For whatever reason if you do, the game will freeze after a minute or so. However, do not have your Procube controller connected to the adapter as you enter whatever gamecube game you're looking to play. However, people have found the mayflash Wii U pro controller to USB connection wireless dongle will allow for this kind of connection on a Wii or Wii U in Nintendont. The procube controller has a bluetooth protocol similar to many 3rd party wiimotes where it doesn't emit a signal long enough or something like that for homebrew to stay connected to it. Plug the adapter into the controller port, then plug the Hyper Blaster into the adapter. Use the Hyper Blaster HD on your RetroN 2 HD or RetroN 3 HD using this adapter. I have one as well and care verify the issue. Hyperkin Hyper Blaster HD Adapter For RetroN 2 HD/ RetroN 3 HD (Bulk) 4.99. Sadly it does not work with Nintendont (without an additional third party device).

Using hyperkin gamecube controller adapter for pc